The air compressor is a component of the
Dot Peen And Scribe Marking system. Let's talk about its concept first. The air compressor is the main body of the air source device. It is a device that converts the mechanical energy of the prime mover (usually an electric motor) into gas pressure energy. It is a compressed air pressure generating device. The following is the maintenance and care of its main components.
1. Air filter element. Under normal circumstances, dust and impurities on the surface of the air filter element should be removed every 500 hours, and check whether it needs to be replaced every 2000 hours. The inspection or replacement cycle can be extended or shortened according to the dust content.
2. Inlet valve seal. Check the condition of the seal ring every 4000 hours of operation of the air compressor of the Dot Peen And Scribe Marking, and replace it if necessary.
3. Compressor lubricant. Check whether the lubricant is sufficient every 1000 hours, and replace it with new oil every 4000 hours.
4. Oil filter. Replace a new part every 2000 hours.
5. Oil-gas separator. Replace a new part every 4000 hours.
6. Minimum pressure valve. Clean it every 4000 hours and check whether the opening pressure is normal.
7. Safety valve. Check whether its action is sensitive every 4000 hours.
8. Oil drain valve. Drain water and dirt every 2000 hours.
9. Drive belt. Adjust the tightness every 2000 hours, check the wear every 4000 hours, and decide whether to replace it according to the wear.
10. Motor maintenance. Perform maintenance according to the motor instruction manual.
In order to make the air compressor of
Pneumatic Dot Peen Marking Machine operate normally and reliably and ensure the service life of the unit, a detailed maintenance plan must be formulated, and designated personnel, regular maintenance, regular inspection and maintenance must be implemented to keep the air compressor unit clean, oil-free and dirt-free.
